When performing field surveys with APEKS GNSS receivers, the Built-in Radio mode is the most reliable method for real-time data transmission between the Base and Rover. However, factors such as signal interference, mismatched settings, or hardware connection issues often lead to radio mode failures and interrupt your workflow.
Below is a detailed analysis of three core issues and a step-by-step troubleshooting guide to help you stay productive.
I. Unable to Establish Connection (Base ↔ Rover)
Common Symptoms:
1.The Rover cannot find the Base signal.
2. The status bar shows “AUTONOMOUS”.
3.The RTK status remains as “Single”.
Troubleshooting Steps:
Note: Different brands use different antenna frequencies. Ensure you are using the correct antenna; APEKS GNSS frequency is 450–470 MHz.
Avoid Mode Errors: Ensure you haven’t accidentally selected “External Radio” or “Network” mode.
II. can connect, but the distance is short (the communication range is insufficient).
1.The theoretical range of 5–15 km drops significantly to only 300–500 m
2.The link disconnects with even minor obstructions.
III. Unstable Data Reception / Frequent RTK Drops
1.RTK status switch rapidly between Fix → Float → Single.
2.High latency or jumping coordinates.
IV. Signal Present but Unable to Achieve “Fix”
1.The status shows “Float” and remains on “Float” for an extended period.
V. No Signal from Internal Radio
1. When configuring a base station, the ApekSurv software does not show “Base”.
2.The Base differential indicator light flashes abnormally.
Problem Type
Key reason
Standard Inspection Points
Built-in radio cannot connect (base ↔rover)
Radio link not established
①Base station is set to Base, and rover station is set to Rover.
② The frequency and protocol must be consistent (APEKS: 450–470 MHz).
③ Different brands require the installation of radio antennas on the corresponding frequency bands.
④ The built-in radio is confirmed to be open, but not choose External Radio / Network.
⑤ After the base station is turned on, ApekSurv show “Base” at the top.
can connect, but the communication distance is short.
Launch conditions or environment are limited
①Adjust the transmit power to the maximum supported by the device.
②Use dedicated radio antenna (not a GNSS antenna).
③Check if the antenna connector is loose or damaged.
④Increase the height of the base station to avoid obstruction by buildings or metal objects.
⑤Stay away from high-voltage lines, communication towers, or dense urban areas.
Unstable Data Reception / Frequent RTK Drops
abnormal radio quality or base station status
①The base is correctly outputting RTCM 3.2.
②The base station is active; ApekSurv displays “Base”.
③Number of satellites ≥15, PDOP reasonable
④Try changing the radio channel and frequency.
The radio has a signal but cannot be fixed.
Satellite conditions or interference
①Number of satellites >18
②Change radio channels and frequencies to avoid interference.
Built-in radio has no signal at all
Antenna, firmware, or hardware abnormal
①Check the radio antenna and interface for damage.
②Confirm that the firmware is the latest version and the upgrade is complete.
③Switching to external radio station test. Determining if it is a built-in radio module problem
If problems persist, please feel free to contact us for further assistance.
Media ContactCompany Name: Shanghai Apekstool (APEKS)Email: Send EmailCountry: ChinaWebsite: https://www.apeksgnss.com/